Changing battery

To install a battery:

Slide the battery compartment cover down (9, Fig. 2)

Install the battery observing polarity

Don’t apply superfluous strength while pushing the battery inside the compartment.

Close the compartment cover

If the battery does not fit the compartment easily, it means that polarity was reversed

To take a battery out:

Slide the battery compartment cover down (9, Fig. 2)

Shake the rangefinder gently towards the open end of the battery compartment

Pull out the battery

The unit is fully operational when battery voltage is higher than 7V. A ‘LOW BATTERY’ warning is displayed when battery voltage falls below 7.2V.

Ni-MH rechargeable or other 9V batteries capable to sustain current drain up to 150 mA could be used to power the System.

10

Page 13
Image 13
Newcon Optik LRM1200, LRM1500SPD operation manual Changing battery To install a battery, To take a battery out