Nikon SB-22 instruction manual Stby Standby Position, On Position, OFF Position

SETTING POWER SWITCH ------------

m 06 1 1.5 3 ft 2 3 4 5 7 10

POWER FLA

UNCE OFF....ST,BY,.oN

• I•

GN(lSO lOa) 25(m)/82(ft)

With other cameras:

Though the ON position is normally recommended for turning on the flash unit, ST8Y can also be used.

With other Nikon cameras, even if the camera 'sexpo- sure meter stays on , the S8-22 automatically turns off when not used for one or two minutes. To turn on again , set power switch to ON or OFF position , then reset to ST8Y. For convenience, you may also push the open-flash button to turn on the S8-22.

STBY (STANDBY) Position

Use to conserve energy and shorten recycling time.

With Nikon F·501/N2020, F·401/N4004, F·301l N2000, FA, FE2 and FG:

Use the S8-22'sST8Y position to turn on the S8 -22. In ST8Y position, when the camera'smeter turns off, in one or two minutes the S8-22 turns off automatically. To turn the S8 -22 on again, lightly press the camera's shutter release button.

Note: Wh en the Nikon FA or FE2 is connected to Nikon Motor Drive MD -12 via a remote cord, the camera 's meter stays on and the 58-22 remains on at STBY position.

ON Position

With cameras other than the Nikon F·501/N2020, F·401lN4004,F·301/N2000, FA, FE2 and FG :

This position is normally used to turn on the S8-22.

With the Nikon FA, FE2, and FG:

To turn on the S8-22 when using mechanical shutter settings (M250, M90 or 8), set power switch to ON.

OFF Position

When not using the flash unit, a/ways set the power switch to OFF position.

33