6.Place entire assembly into hole. Figure 11
7.Turn dog screws clockwise until dogs are snug.
Figure 12
Front view | Rea |
Rear view
Access holes
NOTE: ACCESS HOLES ARE PROVIDED TO LOOSEN DOGS IN CASE THEY BECOME STUCK.
8.Make provisions to view the camera image and point the camera at the desired location.
IMPORTANT: MAKE SURE THAT THE IMAGE IS LEVEL!
9.With camera properly aimed, tighten screws.
10. Align trim ring with slots in bayonnet mount. Snap in place.
11. To remove trim ring, insert small, flat screwdriver tip into one of three slots on outer edge and pry off.
Figure 13
6