Niles Audio CM4PR manual Length of wire from speaker to amplifier, Wire Gauge, PARTS GUIdE

Models: CM4PR

1 7
Download 7 pages 12.23 Kb
Page 3
Image 3
PARTS GUIdE

PARTS GUIdE

PACKAGE CONTENTS – CM4PR

(1)CM4PR loudspeaker with Rear Wave Control enclosure, (1) Magnetically attached round grill, (1) Hole template with painting standoffs, (1) Owner’s manual,

(1)Warranty card

INSTALLATION CONSIdERATIONS

Recommended tools for installation:

 

• Cordless screwdriver

• Measuring tape

• Painters tape

• One inch #2 Phillips tip

• Stud fi nder

• Drop cloth

• 1/8” Drill bit

• Spackle

• Rubber gloves

• Drywall saw

• Wire stripper

• Optional - a 24” x 24”

• Laser plumb bob

• Cable ties

piece of R19 insulation

 

• 12” -14” Coat hanger wire

• Pencil

 

INSTALLATION CONSIdERATIONS continueD

NOTE: BE VERY CAREFUL WHEN LOCATING THE SPEAKERS. VERIFY ALL LOCATIONS ARE CLEAR OF OBSTRUCTIONS BEFORE CUTTING THE FIRST HOLE.

Each speaker requires two-conductor wiring of sufficient gauge. The gauge depends on the length of the wire. For recommendations, please refer to (Figure 2).

Length of wire from speaker to amplifier

Wire Gauge

 

 

Less than 80 feet

16

 

 

80 to 200 feet

14

 

 

More than 200 feet

12

 

 

 

 

Figure 2. Speaker Wire Gauge Guide

CM4PR

3-5/16”PACKAGE CONTENTS – CM4PRINSTALLATION CONSIdERATIONS(INSTALLATION CONSIdERATIONS continueD 8Length of wire from speaker to amplifierWire Gauge.4Less than 80 feet80 to 200 feetcm) DepthMore than 200 feet BeCM4PRhiManual backgroundManual backgroundndManual backgroundManual background Drywall

5” (12.7 cm)

Clearance

CM4PR 4-5/8” (11.75 cm)

Diameter Hole Opening

Figure 1. CM4PR loudspeaker installation dimensions

These require a 4-5/8” (11.75 cm) diameter hole opening with a minimum of 3-5/16” (8.42 cm) depth when measured from the interior face of the drywall, plus at least 5” (11.75 cm) clearance to one side of the loudspeaker opening for the Rear Wave Control enclosure. To the sides of the hole you will need 1” for the mounting tabs to clamp the speaker to the drywall.

When running loudspeaker wire inside walls or ceilings, use special jacketed cable (CL-2 or CL-3 rating) to protect the wire and for fi re prevention. In some municipalities, conduit is required. For a trouble-free installation, low voltage wire such as loudspeaker wire must be in accordance with the National Electrical Code and any applicable provisions of the local building code. If you are unsure of the correct installation techniques, wire jacket, or type of conduit to use, consult a professional audio/video installer, building contractor, or the local building and inspection department.

(CoNTINued oN NeXT pAGe)

WWW.NILESAUDIO.COM

 

NILES AUDIO – 1-800-BUY-HIFI1-760-710-0992

 

5

 

 

Page 3
Image 3
Niles Audio Length of wire from speaker to amplifier, Wire Gauge, PARTS GUIdE, PACKAGE CONTENTS - CM4PR, 80 to 200 feet