Niles Audio MSA-10A manual Installation, Connections, Operation, Specifications

INSTALLATION

CONNECTIONS

NOTE: WHEN CONNECTING THE MSA-10A TO RECEIVERS OR AMPLIFIERS WITH “A” AND “B” SPEAKER SELECTION, CONNECT THE MSA-10A TO SPEAKER POSITION “A”. DO NOT CONNECT ANYTHING

TO SPEAKER POSITION “B” TO PREVENT THE AMPLIFIER FROM DRIVING AN UNUSUALLY LOW IMPEDANCE LOAD.

NOTE TO OWNERS OF TUBE AMPLIFIERS: VIRTUALLY ALL TUBE AMPLIFIERS MUST HAVE A LOAD CONNECTED AT ALL TIMES. IF THE AMPLIFIER TO BE CONNECTED TO THE MSA-10A IS A TUBE AMPLIFIER, BE SURE TO ALWAYS HAVE AT LEAST ONE PAIR OF SPEAKERS SWITCHED ON AT ALL TIMES. AN ALTERNATIVE IS TO PERMANENTLY CONNECT A 150 OHM, 5 WATT RESISTOR ACROSS THE TUBE AMPLIFIER’S OUTPUT IN PARALLEL WITH THE MSA-10A. SEE FIGURE 2 FOR THE HOOKUP DIAGRAM.

Refer to Figure 1 on the following page for hookup diagram. Use #20 through #14 gauge speaker wire for all connections.

The insulation on each wire should be stripped 1/4" – no more – the ends twisted tightly together, then inserted into the appropriate hole on each rear panel terminal block. Secure each wire by tightening the small set screws on the top of the terminal blocks. Be certain that proper “phasing” is observed: connect the positive (+) terminals on the MSA-10A to the positive terminals on the amplifier and speakers and negative (-) terminals on the MSA-10A to the negative terminals on the amplifier and speakers.

OPERATION

Operation is straightforward. Simply depress the button(s) corresponding to the speaker pair(s) you wish to play. To turn a pair off, simply press the button again.

SPECIFICATIONS

Audio Power Handling:	200 Watts per channel (RMS)
	350 Watts per channel (peak music power)
AC Power Requirements:	120-volt to 16-volt AC transformer (supplied)
Overall Dimensions:	17-3/8" wide x 3-7/8" high x 7-5/8" deep
Weight:	15 lbs.

2