CONNECTIONS

Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of the receiver.

Connect the (+) terminals on the receiver and speakers using the corresponding side of the cable. Connect the (−) terminals on both components using the other side of the cable.

Receiver

NS-IW560C

+ −

− +

Notes:

Make sure that the bare wires are not touching each other as this could damage the speaker and receiver.

Connect one speaker to the left terminals of your receiver, and another speaker to the right terminals, making sure no to reverse the polarity (+, −). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

How to connect

1Press and hold down the speaker terminal.

2Insert the bare wire. Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

3Release the terminal. Test the firmness of the connection by pulling lightly on the cable at the terminal.

1

Black (−)

Red (+)

(−)

2

 

When using a banana plug

1Insert the banana plug into the top of the terminal as shown below:

Banana plug

1

(+)

6