Niles Audio SI-2125 manual Step

INSTALLATION

CAUTION! THE AMPLIFIER MUST BE OFF WHENEVER YOU MAKE CHANGES TO THE INPUT CONNECTIONS.

STEP

1.Label all of the interconnecting cables for the sources they connect to.

2.Connect the sources by inserting the RCA plugs into the amplifier’s jacks.

Use audio patch cables with RCA phono plugs attached to the ends.

Connect outputs from your sources to inputs on the amplifier. Never connect a source or preamplifier’s input (e.g., record inputs) to the inputs of your SI-2125.

DESCRIPTION

The “Cascade Audio Outputs” enable you to connect another amplifier to your preamplifier output. The connectors are gold-plated RCA phono jacks. Connect them to another amplifier’s inputs with a standard audio patch cable. The outputs are not buffered; if you wish to daisy-chain more than 5 Niles amplifiers you will need a Niles AVDA-3 buffered distribution amplifier. A single AVDA-3 will allow you to daisy-chain 5 amplifiers from each of its 3 outputs, allowing 15 SI-2125 power amplifiers to be fed from the same master preamplifier. If your preamp has a vacuum tube output stage, you must use a Niles AVDA-3 to drive more than a single SI-2125.

13