Niles Audio SVL-2 manual Or 2 pair of 8-ohm speakers

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

6.Using the appropriate volume control on the front of the SVL-2, adjust the volume of the speakers to the desired listen- ing level.

7.You can turn off the speakers by turning the appropriate volume control on the SVL-2 fully counter-clockwise, or by pressing the ON/OFF button.

Playing Two Pairs of Speakers Simultaneously

1.Make sure the amplifier or receiver power is OFF and set the volume to minimum.

2.On the right side of the SVL-2's front panel is a button labeled PROTECTION. This button activates the SVL-2's imped- ance correction circuitry. The circuitry assures that your receiv- er or amplifier will see a safe operating load when playing two pairs of speaker simultaneously. Since most receivers and amplifiers are not rated for use below a 4 ohm load, you will need to activate the PROTECTION button whenever the over- all system impedance might fall below 4 ohms. Use the follow- ing chart as a guide for setting the PROTECTION button.

When playing the following speakers:	The Protection button should be:
1 or 2 pair of 8-ohm speakers	OFF
1 pair of 4-ohm speakers	OFF
2 or more pairs of 4-ohm speakers	ON
Any combination of 4 and 8 ohm speakers	ON

Set the PROTECTION button to the correct position using the chart shown above.

11