RUNNING WIRES IN WALLS OR CEILINGS
When running wire inside walls or ceilings, use special jacketed cable (CL-2 or CL-3) to protect the wire and to meet local electrical and fire codes. In some areas, conduit is also required. For a trouble-free installation, low-voltage wire such as loudspeaker wire must be run in accordance with the National Electrical Code and any applicable provisions of the local building code. If you are unsure of the correct installation techniques, wire jacket, or type of conduit to use, consult a professional audio/video installer, building contractor, or the local building and inspection department.
CONTROLS AND CONNECTORS
The SWA-500M’s easy operation controls are located on the unit’s front panel, as shown in Figure 6. The controls function as follows:
1Figure 6. Front Panel control on the SWA-500M
1.(Master) POWER Switch: Use this control to power the SWA-500M On or Off.
2.MUSIC/MOVIE LEVEL and SETUP Controls: Because bass levels will differ depending on whether you are watching a movie or listening to music, the SWA-500M includes MUSIC/MOVIE LEVEL and SETUP Controls. While listening to music, push the SETUP switch to MUSIC and adjust the MUSIC LEVEL control to set your desired bass level. Similarly, while listening to a movie, push the SETUP switch to MOVIE and adjust the MOVIE LEVEL control to set the desired bass level. Each level control includes an LED indicator to identify which one is currently active as triggered by your home theater sound processor or receiver. Also see CALIBRATING THE SWA-500M on page 15.
3.LOW PASS Frequency Control: Use this control to set the subwoofer’s low-pass crossover frequency from 40 to 120 Hz. For more details, see CALIBRATING THE SWA-500M on page 15.
4.PHASE Control: Use this control to set the subwoofer’s phase response from 0 to 180°. See CALIBRATING THE SWA-500M on page 15.
| (CONTINUED ON NEXT PAGE) |
NILES AUDIO CORPORATION – 1-800-BUY-HIFI | | 7 |
|
