To edit a packet data access point, open one of the access point groups, and select
an access point marked with .
Follow the instructions from your service provider.
Select from the following:
●Access point name — You obtain the access point name from your service
provider.
●User name — The user name may be needed to make a data connection, and
is usually provided by your service provider.
●Prompt password — If you must enter the password every time you log in to
a server, or if you do not want to save your password in the device, select Yes.
●Password — A password may be needed to make a data connection and is
usually provided by your service provider.
●Authentication — Select Secure to always send your password encrypted or
Normal to send your password encrypted when possible.
●Homepage — Depending on the access point you are setting up, enter the web
address or the address of the multimedia message centre.
●Use access point — Select After confirmation if you wa nt th e devi ce to a sk fo r
confirmation before the connection using this access point is created, or
Automatically if you want the device to connect to the destination using this
access point automatically.
Select Options > Advanced settings and from the following:
●Network type — Select the internet protocol type to transfer data to and from
your device. The other settings depend on the selected network type.
●Phone IP address (for IPv4 only) — Enter the IP address of your device.
●DNS addresses — Enter the IP addresses of the primary and secondary DNS
servers, if required by your service provider. To obtain these addresses, contact
your internet service provider.
●Proxy server address — Enter the address of the proxy server.
●Proxy port number — Enter the port number of the proxy server.
Connectivity
© 2010 Nokia. All rights reserved. 125