2.Insert the card into the microSD card slot with the contact surface facing down, and press it until it locks into place.

Remove the microSD card

Important: Do not remove the memory card in the middle of an operation when the card is being accessed. Removing the card in the middle of an operation may damage the memory card as well as the device, and data stored on the card may be corrupted. You can remove or replace the microSD card during phone operation without switching the device off.

1.Make sure that no application is currently accessing the microSD memory card.

2.Remove the back cover of the device.

3.Press the microSD card slightly in to release the lock and remove it.

Charge the battery

Check the model number of any charger before use with this device. This device is intended for use when supplied with power from the AC-3 and AC-4 charger. The exact charger model number may vary depending on the type of plug. For example, the model numbers for the AC-3 charger can be AC-3C, AC-3U, AC-3X, etc.

Warning: Use only batteries, chargers, and enhancements approved by Nokia for use with this particular model. The use of any other types may invalidate any approval or warranty, and may be dangerous.

For availability of approved enhancements, please check with your dealer. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord.

1.Connect the charger to a wall socket.

2.Connect the lead from the charger to the charger connector of your phone.

If the battery is completely discharged, it may take a few minutes before the charging indicator appears on the display or before any calls can be made.

The charging time depends on the charger used. Charging a BL-4CT battery with the AC-3 charger takes approximately 2 hours 30 minutes while the phone is in the standby mode.

11

Page 12
Image 12
Nokia 5310 manual Remove the microSD card, Charge the battery