74
Network operator time (network service)— to allow the network to update time,
date, and time zone information to your phone. If you select Auto-update, all
active connections are disconnected. Check any alarms as these may be affected.
Enhancement
To ch ang e s ett in gs o f a n en ha nce me nt, in the Enhancement sett. view, scroll to an
enhancement, such as Headset, select Options> Open and from the following
options:
Default profile—to select the profile you want to activate each time you connect
the enhancement to your phone
Automatic answer—to set the phone to answer an incoming call automatically
after 5 seconds when this enhancement is connected to your phone. If the Ringing
type is set to Beep once or Silent, automatic answer cannot be used, and you must
answer the phone manually.
Lights—To set the phone lights continuously on while using the enhancement,
select On.
Security
Select Phone and SIM card, Certificate management, or Security module.
Phone and SIM card
You can change the following codes: lock code, (U)PIN code, and PIN2 code. These
codes can only include the numbers from 0 to 9.
Avoid using access codes similar to emergency numbers to prevent accidental
dialing of the emergency number.
Code in use—to select the active code, PIN or UPIN, for the active USIM. This is
shown only if the active USIM supports UPIN, and the UPIN is not rejected.
PIN code request or UPIN code request—to set the phone to request the code each
time the phone is switched on. Some SIM cards may not allow the PIN code
request to be turned Off. If you select Code in use> UPIN, UPIN code request is
shown instead.
PIN code or UPIN code, PIN2 code, and Lock code—to change the codes
Keypad autolock period> User defined—to automatically lock the keypad after a
defined period of inactivity
Phone autolock period—to set a time-out after which the phone is automatically
locked. To use the phone again, you need to enter the correct lock code. To turn off
the autolock period, select None.