You can sort your landmarks into preset categories, and
create new categories. To edit and create new landmark
categories, open the categories tab, and select Options >
Edit categories.

GPS data

Route guidance

Select > Applications > GPS data and Navigation.
Start the route guidance outdoors. If started indoors, the GPS
receiver may not receive the necessary information from the
satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the destination, and
the approximate distance to it is shown inside the compass
ring.
Route guidance is designed to show the straightest route and
the shortest distance to the destination, measured in a
straight line. Any obstacles on the route, such as buildings
and natural obstacles, are ignored. Differences in altitude are
not taken into account when calculating the distance. Route
guidance is active only when you move.
To set your trip destination, select Options > Set
destination and a landmark as the destination, or enter the
latitude and longitude coordinates.
To clear the destination set for your trip, select Stop
navigation.

Trip meter

Select > Applications > GPS data and Trip distance.
The trip meter has limited accuracy, and rounding errors may
occur. Accuracy can also be affected by availability and quality
of GPS signals.
To turn trip distance calculation on or off, select Options >
Start orStop. The calculated values remain on the display.
Use this feature outdoors to receive a better GPS signal.
To set the trip distance and time and average and maximum
speeds to zero, and to start a new calculation, select
Options > Reset. To set the trip meter and total time to zero,
select Restart.
7. Write text

Traditional text input

is shown on the top right of the display when you are
writing text using traditional text input.
and indicate the selected case. indicates
that the first letter of the sentence is written in uppercase
and all the other letters are automatically written in
lowercase. indicates the number mode.
To write text with the keypad, press a number key 2-9
repeatedly until the desired character appears. There are
more characters available for a number key than are printed
on the key. If the next letter is located on the same key as the
Write text
© 2009 Nokia. All rights reserved. 31