-Make sure the flame does not touch the inside of the flue tube [2].
-If the flame touches the inside of the flue tube, contact your dealer or Norcold authorized service center.
-Close the burner box door.
Remove and clean the burner orifice:
NOTE: A dealer or Norcold authorized service center must do this procedure.
To remove and clean the burner orifice:
-Close the valve at the gas tank(s).
-Close the manual shut off valve of the refrigerator.
3.Remove the AC power cord from the receptacle.
-On
-Remove the DC fuse or remove the DC wiring from the battery or the converter of the vehicle.
-Remove the DC wires from the refrigerator.
4.Remove the screws which attach the rear of the refrigerator to the floor.
5.Remove the screws which attach the refrigerator to the wall.
6.Remove the refrigerator.
-Turn the thermostat to the 1 position and the energy selector to the OFF positon ( 
) .
CAUTION: The burner box cover can be hot. Wear 
gloves to avoid burns.
-Open the lower intake vent.
-Remove the flare nut from the orifice assembly [1] (See Art00956).
-Remove the orifice assembly from the burner [2]
WARNING: When cleaning, do not try to remove the 
orifice [3] from the orifice adapter [4]. Removal will
damage the orifice and seal of the orifice and can cause a propane gas leak. Leaking propane gas can ignite or explode and result in dangerous personal injury or death. Do not clean the orifice with a pin or other objects.
-Clean the orifice assembly with air pressure and alcohol only.
-Using a wrench, assemble the orifice assembly to the burner.
-Assemble the flare nut to the orifice assembly.
-Examine all of the gas connections for leaks.
Remove the Refrigerator
Reinstall the Refrigerator
NOTE: A dealer or Norcold authorized service center must do this procedure.
WARNING: Make sure the seal strips are not broken, 
are completely around the refrigerator mounting flanges, and are between the refrigerator mounting flanges and the wall of the enclosure. If the seal is not complete, exhaust fumes can be present in the living area of the vehicle. The breathing of exhaust fumes can cause dizziness, nausea, or in extreme cases, death.
1.Push the refrigerator completely into the enclosure.
2.Put the screws though the mounting flanges and into the wall.
CAUTION: The rear of the refrigerator has sharp edges 
and corners. To prevent cuts or abrasions when working
on the refrigerator, be careful and wear cut resistant gloves.
3.Open the lower intake vent and put the screws through refrigerator and into the floor.
WARNING: To avoid possible gas leaks, always use 
two wrenches to tighten or loosen the LP gas supply line
at the refrigerator’s manual shut off valve
4.Attach the gas supply line to the manual shut off valve of the refrigerator.
5.Open the valve at the propane gas tank(s).
NOTE: A dealer or Norcold authorized service center must do | WARNING: Do not allow the leak detecting solution to | |
this procedure. | ||
touch the electrical components. Many liquids are | ||
| ||
CAUTION: The rear of the refrigerator has sharp edges | electrically conductive and can cause a shock hazard, | |
electrical shorts, and in some cases fire. |
and corners. To prevent cuts or abrasions when working |
|
|
on the refrigerator, be careful and wear cut resistant | 6. | Using a leak detecting solution, examine the gas supply line |
gloves. | for leaks. | |
1. Close the valve at the propane gas tank(s). | 7. | Connect the DC wiring to the refrigerator: |
WARNING: To avoid possible gas leaks, always use | - | Install the DC fuse and connect the DC wiring to the battery |
two wrenches to tighten or loosen the gas supply line at |
| or the converter. |
the manual shutoff valve of the refrigerator. |
|
|
2. Open the lower intake vent and remove the gas supply line | - | Connect the DC wires from the refrigerator. |
|
| |
from the manual shut off valve of the refrigerator. | 8. | Connect the AC power cord to the receptacle. |
Installation and Owner’s Manual 8
