![](/images/new-backgrounds/1134205/13420535x1.webp)
Refer to the LED matrix. Each INCLINE program is divided into
program you have
selected are shown in the LED matrix. The two columns on
the left side of the LED
matrix will be dark. The first incline setting of the program will be shown in the third column (see the drawing above); the next seventeen incline settings are shown in the seventeen columns to the right.
5Enter your weight if desired.
When an INCLINE program is selected, the current weight setting
will flash in the INCLINE display. Although it is
not necessary to enter
your weight to use an INCLINE program, the CALORIES display will be more accurate if your weight is entered. If you have already entered your weight, or if you do not want to enter your weight, go to step 6. To enter your weight, press the WEIGHT buttons (see step 5 on page 12).
6Ò+Ó button to start the program.
When the button is pressed, the SPEED display will flash and a tone will sound twice. If the incline of the treadmill is higher than 1.5%, it will automatically decrease to 1.5%. After a moment, the walking belt will begin to move at 1.0 mph. Hold the handrails and begin walking.
Refer to the LED matrix. During the first
the next incline setting will flash, and the treadmill will adjust to the next incline setting.Press the START/ENTER button or the SPEED
The speed of the walking belt can be adjusted as desired during the program with the SPEED buttons. The TIME/PACE display will show the time remaining in the program. Near the end of the program, the walking belt will slow to allow you to cool down. During the last ten seconds of the program, the incline will decrease to 1.5%. When no time remains in the TIME/PACE display, the walking belt will slow to a stop. Note: If the RANDOM program is selected, the program will last for 60 minutes. The program can be stopped earlier, if desired, by holding down the STOP button for two seconds.
To stop an INCLINE program momentarily, press the STOP button. The displays will pause and the TIME/PACE display will begin to flash. To restart the program, press the START/ENTER button or
the SPEED Ò+Ó button. To end the program and reset the displays, hold down the STOP button for two seconds.
Note: While an INCLINE program is in progress, the difficulty level of the program can be adjusted, if desired, with the INCLINE buttons. Press the INCLINE Ò+Ó button. The letters ÒMAXÓ will appear in the LED matrix and a number will flash in the INCLINE display for three seconds. This number is the maximum incline that the treadmill will reach during the program. Press the INCLINE Ò+Ó button again. Each time the button is pressed, the maximum incline setting will increase by 0.5%. As the maximum incline setting increases, the difficulty level of the entire program will increase. The INCLINE ÒÐÓ button can be used in the same way to decrease the difficulty level of the program. Note: The incline settings shown in the LED matrix will not change; these are relative incline settings.
7Follow your progress with the six displays.
See step 8 on page 13.
8key from the console.
Make sure that the treadmill is at the lowest incline setting. Remove the key from the console. Store the key in a secure place. In addition, press
the on/off switch to the off position. (See the drawing near the top of page 12.)When the program is completed, remove the
18