NordicTrack NTL07707.1 user manual Connectors should slide together easily, Not to pinch the wires

7. Set the console assembly face down on a soft	7		Console
surface to avoid scratching the console assem-
bly. Hold the Right Handrail (95) near the con-			Wire
sole assembly. Next, insert the console wire into	95	1	Hole
the large hole in the Right Handrail and out of
the top as shown. If necessary, use needlenose				1
pliers to pull the console wire out.
Attach the Right Handrail (95) and the Left
Handrail (not shown) with four #8 x 3/4" Screws
(1) (only two are shown). Make sure that no
wires are pinched. Start all four Screws be-
fore tightening any of them; do not over-
tighten the Screws.
				Console
				Assembly
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star	8
Washer (33) into the bracket and the Handrail
			5	Wire
Crossbar (94) on each side of the console as-
				Tie
sembly (only one side is shown).
			33

Remove the wire tie from the console wire.

Console

Assembly

			94
9. Remove the long tie from the Upright Wire (38).	9
		Console
Have a second person hold the console assem-		Assembly
bly near the Right Upright (78) and the Left
Upright (not shown). Connect the Upright Wire
(38) to the console wire. See the inset drawing.
The connectors should slide together easily
and snap into place. If they do not, turn one	Console
connector and try again. IF THE CONNECTORS
	Wire
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.	78
		38		Console
Attach the console assembly to the Right Upright			Long	Wire
(78) and the Left Upright (not shown) with four
			Tie
5/16" x 3 1/4" Bolts (7) and four 5/16" Star
		10
Washers (10) (only two are shown). Be careful				38
not to pinch the wires.	7
See steps 4 and 6. Tighten the four 3/8" x 5"
Bolts (6).
	9