2.With the help of a second person, set the console assem- bly on the Uprights (85). Make sure that no wires are pinched. Attach the console assembly with four Console Bolts (72), Washers (96), and Star Washers (67) (only one side is shown). Start all four Bolts before tightening them.
3.With the help of a second person, carefully tip the tread- mill onto its side as shown.
Insert an Extension Leg (97) into the indicated bracket on the base of the Uprights (85). Make sure that the Extension Leg is turned so the Base Pad (81) is on the side shown. If necessary, use a rubber mallet to align the holes in the Extension Leg with the holes in the bracket.
Attach the Extension Leg (97) with two Extension Leg Bolts (87), Washers (96), and Nuts (106) as shown.
Firmly tighten the Nuts.
With the help of a second person, carefully tip the tread- mill onto its other side. Attach the other Extension Leg
(97)as described above.
4.Attach the four Base Pads (81) to the base of the Uprights
(85)in the indicated locations with four 1” Tek Screws
(82)and four Plastic Spacers (115). Note: One replace- ment Base Pad may be included. Use the Base Pad to re- place any Base Pad that becomes worn.
With the help of a second person, carefully tip the tread- mill down so the four Base Pads (81) are resting on the floor and the Uprights (85) are in the vertical position.
2 |
|
|
|
| 85 |
|
|
| 67 |
|
|
| 96 |
| Console |
|
| Assembly | |
|
|
| |
|
|
| 67 |
|
|
| 96 |
| 72 |
|
|
3 |
|
| Bracket |
|
|
| |
|
|
| 87 |
|
| 106 | 96 |
|
|
| |
|
|
| 97 |
|
|
| 81 |
|
|
| 85 |
4 |
| 115 |
|
| |
|
| 81 |
|
| 82 |
|
| 115 |
|
| 85 |
|
| 115 |
| 55 | 81 |
|
| |
|
| 82 |
|
| 115 |
7
