5.Cut the tie securing the Pulse Wire (74) to the Upright Base (85). Hold the Pulse Bar Assembly (69) near the crossbar on the Upright Base (85). Connect the Pulse Wire to the wire in the Pulse Bar Assembly. The connec- tors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the wires into the crossbar.

Open parts bag B. Attach the Pulse Bar Assembly (69) to the crossbar on the Upright Base (85) with four Pulse Bar Bolts (127) and Star Washers (67). Start all four Pulse Bar Bolts before tightening them. Make sure that no wires are pinched.

If you have purchased an optional chest pulse sensor, follow step 6 to install the receiver included with the chest pulse sensor. If you have not, go to step 7.

6.Place the console assembly face-down. Be careful not to scratch the face of the console. Remove the indicated 3/4” Screw (7) and the Access Door (95) from the left side of the Console Back (96).

Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (96). Hold the receiver so the small cylinder is oriented as shown and is fac- ing the Console Back. Attach the receiver to the plastic posts on the Access Door (95) with the two included small screws.

Make sure that no wires are pinched. Reattach the Access Door (95) with the 3/4” Screw (7). Discard the other wires included with the receiver.

7.Cut the tie securing the wires to the Upright Base (85). Have a second person hold the console assembly near the Upright Base. Connect the Upright Wire Harness (73) and the Pulse Wire (74) to the wires extending from the console assembly. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the connectors into the console as- sembly. If necessary, remove the right accessory tray (not shown) from the console assembly.

Connect the Upright Ground Wire (113) to the ground wire extending from the console assembly. Make sure that the wires are fully inserted into each other. Insert the ground wires into the console assembly. Reinsert the right acces- sory tray (not shown) into the console assembly if neces- sary.

5

 

127

 

67

 

85

127

 

67

74

 

69

 

74

 

6

 

7

 

Small

95

 

Cylinder

 

A

96

 

Wire

 

Small

 

Screws

 

7

 

Console

 

Assembly

 

Ground

74

Wire

 

113

73

73

85 74

8

Page 8
Image 8
NordicTrack NTL12950 user manual