ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver 
, wire cutters 
, and rubber mallet 
.
Note: The underside of the treadmill walking belt is coated with
For help identifying the assembly hardware, see the PART IDENTIFICATION CHART on page 31.
1.With the help of a second person, carefully raise the Uprights (69) to the position shown.
See the inset drawing. Insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is under- neath it. Note: It may be helpful to tip the Uprights (69) forward and tap on the Extension Leg with a rubber mal- let as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
2.Press the Lock Knob Sleeve (70) into the left Upright (69).
Remove the Lock Knob (68) from the Lock Pin (74). Make sure that the Lock Pin Collar (72) and the Spring (71) are on the Lock Pin.
Insert the Lock Pin (74) into the Lock Knob Sleeve (70) and the left Upright (69). Tighten the Lock Knob (68) back onto the Lock Pin.
3.Fold the treadmill into the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 26). Orient the Left Rear Foot (140) and the Right Rear Foot (141) as shown. Attach the Left and Right Rear Feet to the Frame (110) with four 1” Tek Screws (26). Be careful not to overtighten the Screws.
Lower the treadmill Frame (110) (see HOW TO LOWER THE TREADMILL FOR USE on page 26).
1 |
|
| 69 |
| 69 |
| 102 |
| 99 |
2 |
|
| 68 |
| 71 |
| 72 |
| 74 |
| 70 |
| 69 |
3 |
|
| 140 |
| 141 |
26 | 110 |
| 26 |
6
