NordicTrack NTL16950 user manual Extension 90 remains in place, Do Not, Cut

2.With the help of a second person, carefully tip the Uprights (20) and the Walking Platform (not shown) down to the position shown. Make sure that the Base

Extension (90) remains in place.

Attach the Base Extension (90) with four Extension Screws (87); start all four Extension Screws before tightening them.

Next, attach the four Base Pads (83) to the base of the Uprights (20) in the locations shown with four 1” Tek Screws (82). Note: One replacement Base Pad may be in- cluded. Use the Base Pad to replace any Base Pad that becomes worn.

With the help of a second person, carefully tip the Uprights (20) back to the vertical position.

3.Slide the two Upright Covers (75) onto the ends of the Pulse Bar (69). Align the holes in the lower ends of the Pulse Bar with the holes in the Uprights (20).

Cut the tie securing the Pulse Wire (74) to the right Upright (20). Do not cut the indicated black tie. Connect the Pulse Wire to the Pulse Bar Wire (79). The connec- tors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the wires down into the right Upright.

Hold the Pulse Bar (69) against the Uprights (20). Do not drop the Pulse Bar into the Uprights. Attach the Pulse Bar with the four Pulse Bar Bolts (66) and four Star Washers (67). Be careful not to pinch the wires. Start all four Pulse Bar Bolts before tightening them.

Slide the Upright Covers (75) over the Pulse Bar Bolts (66).

4.Press the Upright Covers (75) onto the Uprights (20). Attach each Upright Cover with a 3/4” Screw (7). Be care- ful not to damage the wires in the right Upright.

2
		83
		82
83	82	87
		20
	87
		90
3
75		69
	67	Do Not
66		Cut
	20
		75
	79	79
		20
	74	67
		74
		66
4
	Wires	75
	75
	7	7
	20	20

7