ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench | and your own phillips screwdriver | . To |
avoid damaging plastic parts, do not use power tools for assembly. |
| |
For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags, check to see if the part has been preattached.
|
| Upright Star | Handrail Star | Handrail Bolt | |
Washer | Washer |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3/4” Screw | Upright Bolt |
Washer
1.Identify the Right Upright (74), which is marked with a sticker. Place the Right Upright near the right side of the treadmill. Next, identify the lower end of the Right Upright, which has three small holes. Feed the Upright Wire Harness (75) into the lower end of the Right Upright and out of the upper end as shown.
See the inset drawing. Place the Left Upright (73) near the left side of the treadmill. Feed the TV Cable (110) into the lower end of the Left Upright and out of the upper end as shown.
Stretch the included elastic bands around the upper ends of the Uprights (73, 74) to hold the TV Cable (110) and the Upright Wire Harness (75). Do not remove the elas- tic bands until you begin step 6.
1 |
|
|
| |
|
| 74 | Small | |
Band | 75 | Holes | ||
| ||||
| 73 |
|
| |
Band | 110 |
|
| |
|
|
|
7
