NordicTrack NTTL09990 user manual Assembly, Your own phillips screwdriver

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

	1. With the help of a second person, carefully raise the	1
	treadmill to the upright position.
	While a second person tips the treadmill to one side
	and holds it, insert one of the Extension Legs (102) into
	the treadmill as shown. Make sure that the Extension
	Leg is turned so the Base Pad (99) is on the bottom.
	Next, tip the treadmill to the other side and insert the
	other Extension Leg (not shown) in the same way. Lower
	the side of the treadmill so that both Extension Legs
	(102) are resting flat on the floor.			102
						99
	2. With the help of a second person, carefully lower the	2
	treadmill frame and then tip the Uprights (69) down as
	shown. Make sure that the Extension Legs (102) re-
	main in the Uprights.
	Attach each Extension Leg (102) with two Screws (80) as		99
	shown.		Frame
	With the help of a second person, carefully tip the					69
	Uprights (69) back to the vertical position.		69
						80
	Note: One replacement Base Pad (99) may be included.
			80			102
	Use the extra Pad if one becomes worn or needs to be re-
	placed.		99
			102
	3. Place one of the Handrail Spacers (65) on the right	3	Cutout		A
	Upright (69) as shown, with the cutout toward the tread-
	mill (see inset drawing A). Pull the Upright Wire Harness		81
	(98) up through the Handrail Spacer. Place the other
	Handrail Spacer on the left Upright (not shown).			66		69
	Have a second person hold the Handrails (66) near the					65
	Uprights (69) as shown. Connect the Upright Wire		98	69	B	98
	Harness (98) to the wires extending from the right
	Handrail. Insert the connectors and the Wire Harness
	(98) into the hole in the Console Base (81) (see inset
	drawing B).
	Be careful not to pinch the Wire Harness (98) as you set		65
6						81
	the Handrails (66) on the Spacers (65).