Nortel Networks 2212, 2211 manual Setting up the Wlan Handset

18Chapter 2 WLAN Handsets overview

Table 3 States of the WLAN Handset

State	Description
Active (on-hook)	This state is entered when the handset is in standby state and the user presses the Menu
	key. The handset appears to be on-hook from the Call Server point of view, and loud
	ringing will occur (when required). The handset display is active and the Menu, FCN and
	Line menus can be accessed. The user returns to the standby state by pressing the
	Power Off/End Call key. If no keys are pressed for a period of 10 seconds, the state times
	out and the handset returns to the standby state. Pressing the Power Off/End Call key in
	any of the menus will exit the menu. Pressing the Power Off/End Call key again will
	return the handset to standby state.
	If the user selects any menu item or presses a soft key, the handset changes into the
	active (off-hook) state, the timeout condition is removed and the handset will use a soft
	ring.
Error	The handset enters the error state when it loses the signal from the access point.
	If the handset regains the signal within approximately 20 seconds, it returns to the state it
	just left. If the handset is out of range for longer than 20 seconds, the handset restarts and
	returns to the standby state.
	For more information on error messages, see “Display messages” on page 44.
Active call	The handset enters the active call state when a user is in an active conversation. To enter
	this state, the user either makes a call or answers an incoming call. While in this state, the
	handset will use a soft ring to alert the user to another call. The user leaves this state
	when the call is completed by pressing the Power Off/End Call key or if an incoming call
	is ended before the user answers it.
Push-to-Talk	The push-to-talk state begins with the first push-to-talk transmission and ends when there
(WLAN Handset	has been no two-way radio traffic on the channel for 10 seconds.
2211 only)	While in the push-to-talk state, it is not possible to use the keypad for any other functions.
	However, it is possible to place and receive telephone calls.

Setting up the WLAN Handset

This section describes the following initial setup options for your WLAN Handset:

•“To select the Keypad Autolock” on page 19

•“Select the Language” on page 19

•“Ring Options” on page 20

•“Phone Options” on page 24

•“Configure push-to-talk” on page 26

•“Adjust speaker volume” on page 27

•“Silence the ringer” on page 27

•“Lock and unlock the keypad” on page 28

NN40050-101