Installation 7
Remote Gateway 911x Series Quick Start Guide
Standard 1.1
4Close and latch the ferrite bead.
Note: You may need to adjust the cable loops to make them as tigh t as
possible.
Installing the Remote Gateway 911x unit
To install the Remote Gateway 911x unit on a desk, attach the rubber feet to the
bottom and continue with “Connecting the Remote Gateway 911x series unit
to the network” on page 7. To install the Remote Gateway 911x unit on the wall,
refer to the Remote Gateway 911x Series Installation and Administration Guide
(555-8421-220).
Connecting the Remote Gateway 911x series unit to the network
To route calls over the IP network, or administer the Remote Gateway 911x series
unit from another location on the IP network, connect the unit to the Ethernet
network by doing the following:
1Plug one end of a 10BaseT Ethernet cable (with an RJ-45 connector) to the
ETHERNET jack on the Remote Gateway 911x series unit.
Note: You must supply your own 10BaseT Ethernet cable with RJ-45
connectors. Contact your system administrator for the correct cable.
2Plug the other end of the 10BaseT Ethernet cable to either an Ethernet hub or
network router.
To connect the Remote Gateway 911x series unit to the analog line:
1Plug the RJ-11 cable into the 911x unit LINE connector.
2Plug the other end of the cable into the analo g line jack.