Nortel Networks SFINA286V13 Removing a Cwdm Gbic, Inserting a Cwdm Gbic into the switching module

Figure 3 Inserting a CWDM GBIC into the switching module

9708FA

Removing a CWDM GBIC

Use the following procedure to remove a CWDM GBIC. When storing a CWDM GBIC, place a dust cover over the fiber optic bores.

Note: When disposing of a CWDM GBIC, comply with all national laws and regulations.

To remove a CWDM GBIC from the switching module:

1Disconnect the fiber cable from the CWDM GBIC connector.

2Grasp the extraction tabs (Figure 1) located on either side of the CWDM GBIC between your thumb and forefinger.

3Slide the CWDM GBIC out of the Gigabit Ethernet module slot.

4If the CWDM GBIC does not slide easily from the module slot, use a gentle side-to-side rocking motion while firmly pulling the CWDM GBIC from the slot.

10