WARNING This generator is equipped with a grounding screw located on the rear of the generator for your protection. Always complete the grounding path from the generator to a copper pipe/rod that is driven into moist earth, to prevent electrical shock.
ALWAYS use electrical cords that are in good condition. Worn, bare, frayed or otherwise damaged cords can cause electric shock.
NEVER operate the generator, or handle any electrical equipment while standing in water, while barefoot, while hands are wet or while in the rain or snow. Electric shock may result.
ALWAYS use a ground fault circuit interrupter (GFCI) in damp or highly electrical conductive areas and on construction
ALWAYS remove the spark plug or spark plug wire before working on the engine or generator, to prevent accidental starting.
ALWAYS provide adequate ventilation. Do not operate generator in any enclosed or narrow space. Engines consume oxygen and give off deadly
carbon monoxide poisonous gas. Improper ventilation will cause damage to generator and possible injury to people.
NEVER touch hot muffler, hot exhaust manifold or engine cooling fins.
ALWAYS remove all oil or fuel deposits and accumulated dirt from generator and immediate area. Keep generator and engine clean.
NEVER operate the generator under the following conditions:
A.Excessive change in engine speed, slow or fast.
B.Overheating in load connecting devices.
C.Sparking or arcs from generator.
D.Loss of electrical output.
E.Damaged receptacles.
F.Engine misfire.
G.Excessive vibration.
H.Enclosed compartments, or confined areas.
I.Flame or smoke.
J.Rain, snow or wet conditions.
K.Operator
WARNING Check fuel system on a regular basis. Look for signs of leaks, deterioration, chafed or spongy fuel hose, loose or missing fuel hose clamps, damaged fuel tank or a defective fuel
WARNING Keep fire extinguisher close by your generator and be familiar on how to use it. Consult your local fire department for correct extinguisher type.
INSTALLATION
OUTDOORS: Choose a location where the generator will not be exposed to rain, snow or direct sunlight. Position the generator on secure, level ground so it will not tip or slide down a hill. Place the generator so that the exhaust fumes will not be directed towards people.
The installation site must be free from water, moisture, or dust. All electrical components should be protected from excessive moisture or the insulation system will deteriorate and result in grounding or shorting out the generating system.
Foreign matters, such as dust, dirt, sand, lint, or abrasive materials can cause damage to the generator head and engine if allowed into its cooling system.
NEVER install your generator inside confined areas. Inside installation can cause health hazards or death.
DANGER Remember, exhaust fumes are deadly carbon monoxide gas, and must be vented to the outside where there are no people. Cooling air of sufficient amounts must be brought in and exhausted out to ensure proper cooling of the engine and generator head.
LOAD APPLICATION
It is important to determine the total electrical load before it is connected to the generator. The two major factors in determining the life of a generator head are: heat build up, caused by overloading the generator and corrosive contaminants, that attack the wiring insulation. If the generator is overloaded, the wires become excessively hot and cause the insulation to break down, reducing its ability to resist corrosive
6
