North Star M268180M Operation Preparing the Sprayer for Each Use, Important safety rules

Operation – Preparing the Sprayer for Each Use

If the sprayer has been used previously, it must be prepared BEFORE EACH SUBSEQUENT USE.

WARNING

Read instructions below carefully for inspecting and preparing the sprayer. Damaged or clogged equipment could result in leaks or uncontrolled spray.

Leaks could result in injury to the operator or bystanders from chemical exposure, or cause damage to the environment.

Important safety rules:

•Power off. Make sure all power is OFF before cleaning, inspecting, or servicing the sprayer.

•Guards / shields. Make sure all guards and shields are replaced after servicing the sprayer.

•Replacement parts. If a part needs replacement, only use parts that meet the manufacturer’s specifications. Replacement parts that do not meet specifications may result in a safety hazard or poor operation of the sprayer.

1.	Ensure sprayer	Ensure the sprayer is securely attached to the vehicle.
	attached
2.	Ensure tank	Ensure the sprayer has been thoroughly flushed and drained of all residual
	empty	chemical from prior uses.
3. Clean suction		Clean the suction strainer of any chemical residue.
	strainer	It is important to clean the suction strainer before each use to ensure it is not
		clogged and to prevent residual chemical from contaminating sprayer contents.
		IMPORTANT: The strainer must be accessed by reaching into the tank, so the
		tank must be empty to avoid immersing your hand in chemicals.
		a) Open fill cap on top of tank.
		b)	USING RUBBER GLOVES, reach into the tank and pull the suction
			strainer off the end of the suction tube. (See figure below.)
		c)	Run the suction strainer under fresh water to remove debris.
		d)	Replace the suction strainer onto the end of the suction tube.
			Fill cap

	),*
	Suction strainer
	(Inside tank)
4. Inspect &	Inspect and test the sprayer thoroughly:
repair	a) Inspect hoses for exposed mesh and holes. Replace all worn or damaged hoses.

b)Inspect fittings for cracks and leaks. Replace all damaged fittings with original NorthStar parts.

c)Inspect tank for cracks.

d)Check to be sure all nuts, bolts, and screws are tight.

e)Partially fill tank with plain water and spray to test for leaks. Repair as needed.

IMPORTANT: After any repair work has been done, ALWAYS test for leaks with water one final time before using.

20