Page:
3 of 7
1. Wear proper clothing. Always use ANSI-approved safety impact gog gles wh en
assembling or using this cutoff tool. Wear long sleeve d shirts, long pants and hard-to ed
shoes. Take off any loose fitting jewelry and keep long h air cove red to prevent being
caught in moving parts.
2. Wear proper breathing protection. Remember that a “dust mask” is not a breathing
respirator. Use a respirator that us es charcoal filters for the best protec tion.
3. Keep work area clean and well lighted. A dim and/or cluttered wo rk area invites
personal injury.
4. Keep children and pets away from work areas. Children c an be a distraction and
should be supervised by an adult when near t he work a rea. Never al low children to play
with this product even if it is turned off.
5. Store idle tools properly. Keep this cutoff too l out of the reach of children and untrain ed
operators.
6. Do not use the cutoff tool if under the influence of al cohol or prescription drugs.
Doing so may cause damage to the tool , or personal injury. Do not use this or any tool if
you are tired. Use common sense at all times.
7. Check for damaged parts. Before using this cutoff tool, carefully check for any parts that
may be missing or d amaged and any other conditions that may a ffect the operation of t his
tool. Replace or repair damaged and worn parts immediately using only qualified repair
facility.
8. Always use the proper tools. This cutoff tool was designed for a specific task. Do not
alter this tool, or use it for a purpo se for which it was not intended.
9. Be careful when connecting/disconnecting air supply. It is recommended to use
quick-disconnects (not included) rather than screw-on air connections .
10. Use co mpressed air onl y. Clean, dry regulated comp ressed air at 90 PSI. Never use
oxygen, carbon dioxide, c ombustible gases, or any other bottl ed gas as a po wer source
for this tool.
11. Always disconnect air supply when this tool is not being used.
12. Take caution as some woods contain preservatives suc h as copper chromiu m
arsenate (CCA) which can be toxic. When cutting these materials, extra care should be
taken to avoid inhalation and mini mize skin contact.
13. 3" Cutting wheel: Only use a standard 3" cutting disc (rated at 18,000 RPM or greater)
with this air high speed cutter. Never use any other type of disc, blade or cutter on this air
tool. This may cause the tool to op erate incorrectly.
NOTE: The warnings, cautions, and instructions discussed in this instructio n man ual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors that ca nnot be
built into this product but must be supplied by the operator.
NOTE: READ ALL INSTRUCTI ONS BEFORE USING THIS PRODU CT