MIXER QUICK SETUP
1.Make sure all items listed on the front of this guide are included in the box.
2.READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT.
3.Study this setup diagram.
4.Place mixer in an appropriate position for operation.
5.Make sure all devices are turned off and all faders and gain knobs are set to “zero”
6.Connect all stereo input sources as indicated in the diagram.
7.Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources.
8.Plug all devices into AC power.
9.Switch everything on in the following order.
•audio input sources (i.e. turntables or CD players)
•mixer
•last, any amplifiers or output devices
10.When turning off, always reverse this operation by,
•turning off amplifiers
•mixer
•last, any input devices
11.Go to http://www.numark.com for product registration.
More information about this
product may be found at http://www.numark.com
REAR CONNECTIONS
1.Phono Inputs: This input is used for connecting your turntables through the sensitive RIAA phono preamplifiers. Only turntables with phono level output should be attached. Line level turntables must be attached to the line inputs.
2.GND: This screw connector should be used to secure any turntables or other devices connected to the mixer that need to be grounded.
3.Line Inputs: CD players, Tape Decks, Samplers or other line level input devices should be connected to these inputs.
4.Microphone Input: Microphones with a ¼” connector can be connected to these input terminals.
5.Fader Start Connector: to attach your mixer to a remote start equipped Numark CD player using industry standard 1/8”(3.5mm) cables.
6.Record Output: This RCA output is for connecting a recording device such as a tape deck or CD recorder. The level of the record output is based upon
7.Zone Output (RCA): This output is for connecting an external monitoring device such as a PA system, powered monitors or a home stereo. The level of the zone stereo output signal is controlled by the zone fader.
8.Master Output (RCA): This output is for connecting an external monitoring device such as a PA system, powered monitors or a home stereo. The level of the master stereo output signal is controlled by the master fader.
9.Stereo Balanced Master Outputs (XLR): low- impedance XLR type connectors controlled by the Master fader.
10.AC In: This mixer is designed to work with the power supply cord that comes with the unit. While the power is switched off, plug the power supply into the mixer first, then plug it into the outlet.
11.Voltage Selector: Set this to the correct voltage for your location standard.
12.Power Switch: Use this switch to turn on the mixer after all input devices are already connected to prevent damage to your equipment. Turn the mixer on before you turn on amplifiers and turn of amplifiers before you turn off the mixer.
3
