Numark Industries TT-1650 manual Problem, Cause?, Solution, Trouble Shooting, Page

Problem	Cause?	Solution
Turntable does not turn on.	Disconnected Power Cord?	Connect Power Cord.
The sound level is very low.	The Turntable is not connected to a	Connect the device to a preamp DJ
	device with a PHONO preamp.	mixer or an AV receiver that has an
		input labeled PHONO, not AUX or
		LINE.
The sound is on one side only.	The Cartridge is not properly wired.	Reconnect the wires from the
		headshell to the cartridge. See the
		"Cartridge Setup" section for more
		detail.
	The Stylus is worn out.	Replace the stylus on the cartridge.
		Replacement styli are available
		from most Numark Retailers.
	The RCA audio cord is	Properly secure the RCA cable to
	disconnected.	the preamp device and the bottom
		of the turntable. See the "Cable
		Connections" section for more
		detail.
	The RCA audio cord is damaged.	If the RCA cord is frequently
		connected and disconnected, it
		may have become damaged and
		needs to be replaced.
The output sound is very distorted.	The Cartridge is not properly wired.	Reconnect the wires from the
		headshell to the cartridge. See the
		"Cartridge Setup" section for more
		detail.
	The Stylus is worn out.	Replace the stylus on the cartridge.
		Replacement styli are available
		from most Numark Retailers.
The Output sound exhibits	The Turntable Grounding wires are	Connect the Turntable Ground
excessive hum or buzzing.	not connected.	wires to their respective Grounding
		Lug on all equipment (mixer, etc.)
The turntable skips like crazy.	The Turntable is on an unstable	Follow the guidelines for installation
	surface.	in the "Setup & Installation"
		Section.
	The Tone Arm is not balanced	Follow the guidelines for optimum
	properly.	setup in the "Tone Arm Setup"
		Section.
	The Stylus is worn out.	Replace the stylus on the cartridge.
		Replacement styli are available
		from most Numark Retailers.
	Excessive force is being applied	Reread the "Operation" section of
	directly down on the platter.	this manual.

The record is warped.

Buy new records.

NOTE:

Static electricity and/or other external interference may cause this unit to malfunction. To reset the unit to its normal condition, turn the power off and then on again. If the problem continues to persist, refer to the connected component's troubleshooting guides. If the problem is not resolved after checking these items, contact the nearest authorized Numark dealer.

TROUBLE SHOOTING PAGE 14