MODELS 741BRNT • 741SNNT • 741WHNT • 741BRFLNT • 741WHFLNT
Existing Construction
4.Place housing in opening so that its bottom edge is flush with finished ceiling. Nail to joist through keyhole on both sides. To ensure a
Page 3
CONNECT THE WIRING
| SCHEMATIC WIRING DIAGRAM | ||||
L I G H T | R E D | B L U L I G H T W H T | |||
S W I T C H |
| ( W H I T E ) | |||
V E N T | B L K | B L K V E N T W H T | |||
S W I T C H | |||||
| ( B L A C K ) | ||||
| B L K |
| |||
|
|
|
| ||
L I N E W H T | W H T |
|
| ||
I N | G R D | G R D |
|
| |
|
|
| |||
| S W I T C H B O X |
| U N I T |
| |
| BLACK |
| RED | WHITE | |
|
| RECEPTACLE | |||
| WHITE |
| GROUND | (LIGHT) | |
| BLUE |
| (bare) | BLACK | |
|
|
| |||
DUAL CONTROL |
|
| RECEPTACLE | ||
(purchase separately) SWITCH BOX |
|
| (FAN) | ||
LIGHT |
|
|
|
| |
FAN |
|
|
|
| |
|
|
| WIRING |
| |
|
|
| PLATE |
| |
ADDITIONAL
MOUNTING
HOLES
5.Additional mounting holes are provided for installations where access from above is inconvenient or not possible. Nail or screw housing directly to joists or framing.
|
|
| 1. Wire unit following diagram |
|
|
| above. Run electrical cable as |
120 VAC | |||
LINE IN | direct as possible to unit. Do not | ||
|
|
| allow cable to touch sides or top of |
|
|
| unit after installation is complete. |
1.Locate the grille pan over the fan housing and con- nect the wiring harness plug into white receptacle in the fan housing.
2.Insert rod through center hole of grille pan. Use washer between collar on rod and pan.
GRILLE 
GRILLE
PANSCREW
WASHERCOLLAR
ROD 
NOTE: The duct connector has a
"open" approx. 1" when duct connector is attached to hous- ing. This design permits insulation to be in direct contact with fan/light housing per UL (Underwriters Laboratories) stan- dards. The slightest backdraft, however, will close the damper flap, preventing air from entering unit or finished space.
1.Snap the damper/duct connector onto housing. Make sure that tabs on the connector lock into slots in housing. Top of damper/duct connector should be flush with top of hous- ing.
2.Connect 4” round duct to damper/duct connector and ex- tend duct to outside through a roof or wall cap. Check damper to make sure that it opens freely. Tape all duct connections to make them secure and air tight.
3.Thread rod onto grille screw in housing, until pan is tight against ceiling.
MODELS | MODELS |
741BRNT | 741BRFLNT |
741SNNT | 741WHFLNT |
741WHNT |
|
4. Install bulbs. (see "Bulb Replace- ment" chart on next page for proper
bulbs for your model).
5. Place glass shade over mounting
rod and align shade onto grille pan. Secure glass shade to grille pan with
finial cap and finial nut as shown.
6. Restore electrical power and check operation of the unit.