MODEL7 44FLNT
3. Pound in nails.
Remove unit temporarily, and pound nails partially into joists at all four marked locations.
Page 3
VERTICAL |
POWER CABLE |
CONNECTION |
HORIZONTAL POWER |
CABLE CONNECTION |
6. Choose power cable direction.
Remove wiring plate. When
7. Connect wiring.
Unit can be wired from outside of housing as shown. Use UL approved connectors to wire per local codes.
4. Hang and secure housing.
Hang unit from nails. Check to make sure that there will be a 1/8” gap between bottom of housing and ceiling material. Pound nails tight. For wide joist centers: A #8 x 3/8
BLUE AND
BLACK
TO BLACK
WHITE TO
WHITE WIRING PLATE
TOP / BACK
OF HOUSING
GROUND TO
WIRING PLATE
GROUND
POWER
CABLE
around mounting brackets.
Fan and Light operated with single on/off switch
FLUSH
5. Attach damper/duct connector.
BLUE (FAN)
TO
BLACK
WHITE TO WHITE
WIRING PLATE
TOP / BACK OF HOUSING
BLACK (LAMP) TO RED
GROUND TO
WIRING PLATE
GROUND
POWER
CABLE
Snap the damper/duct connector onto housing. Make sure that tabs on the connector lock in housing slots. (Top of damper/duct connector will be flush with top of housing.) Install ductwork.
Fan operated with separate on/off switch, speed control or timer.