NuTone installation instructions Indoor Remote Control, Model ICA-441WH, Wiring Connections

READ & SAVE THESE INSTRUCTIONS!

INSTALLATION INSTRUCTIONS

Indoor Remote Control

MODEL: ICA-441WH

•For use with IMA4406, IM4406, IMA4006 or IM4006 Series Systems to operate the ISA-78, IS-82, IS-76, IS-903, IS-905 and IS-908 Speakers.

•IMPORTANT: Speakers that do not have built-in controls require a separate remote control. Model ICA-441WH is designed for indoor use only.

ROUGH-IN FRAME MOUNTING

1.The remote control may be recess-mounted to the Model IR-91 Rough-In Frame.

2.The wiring should be installed when the system is roughed-in.

3.The remote controls require NuTone Model IW-6 3-twisted pair (6 wire) cable from the master station to the remote control location. NuTone Model IW-2 2-conductor twisted pair (22/2) cable is used from the remote control to the speaker. See instructions packaged with the rough-in frames.

WIRING CONNECTIONS

1.Refer to Figure 1. As illustrated, connect wires from the master unit to the six (6) screw terminals. Red wire to the terminal marked red, red/white wire to the terminal marked red/white, etc.

3.Refer to Figure 2. Connect IW-2 cable from the speaker to the remote control's two (2) speaker wires.

RED			ORANGE
RED/WHITE	BLACK	BLACK/WHITE	ORANGE/WHITE
			FIGURE 1

IMPORTANT – WHEN NUTONE MODEL IW-6R

WIRING IS USED:

CONNECT TO SCREWS ON PRINTED

CIRCUIT BOARD MARKED:

1 ORN

2 BLK

3 BLK/WHITE

4 ORN/WHITE

5 RED

6 RED/WHITE

ICA-441WH

CIRCUIT

BOARD

IW-2 CABLE TO SPEAKER

BLUE STRIPE

FIGURE 2