NuTone ICA-441WHW installation instructions Location, Frame Wiring, Frame Mounting

READ & SAVE THESE INSTRUCTIONS!

INSTALLATION INSTRUCTIONS

Outdoor Remote Control

MODEL: ICA-441WHW

•This model is designed for outdoor use only with IMA4406, IM4406, IMA4006 or IM4006 Systems to operate the ISA-77, IS-79 or IS-903 Outdoor Speakers.

•Use Model ICA-441WH for indoor installation.

LOCATION

1.Locate the remote control near the speaker which it will control.

2.Locate the remote control where it can be easily

operated – 50˝ to 60˝ above the floor or ground is satisfactory.

FRAME WIRING

Refer to Figure 1.

1.Run NuTone Model IW-6 intercom wire from master station to location of frame.

2.Run 2-conductor wire (IW-2) from remote control location to speaker location.

3.Pull wires through hole in back of frame.

IMPORTANT: Use only NuTone specified wire.

FRAME MOUNTING

The frame must be mounted in horizontal position, as shown in Figure 1.

1.Nail or screw frame to finished wall surface through four (4) mounting holes.

2.Frame should be caulked around edge which is flush to wall.

WIRING CONNECTIONS

MOUNTING FRAME

MUST BE MOUNTED

IN HORIZONTAL

POSITION

IW-6

CABLE

IW-2

CABLE

FIGURE 1

ICA-441WHW

PRINTED

CIRCUIT

BOARD

GASKET TAB

PLASTIC CLIP

FIGURE 2

1.Refer to Figure 2. Remove plastic clip that holds the rubber gasket to the printed circuit board.

2.Refer to Figure 3. As illustrated, connect wires from the master unit to the six (6) screw terminals. Red wire to the terminal marked red, red/white wire to the terminal marked red/white, etc.

3.Refer to Figure 4. Connect IW-2 cable from the speaker to the remote control's two (2) speaker wires.

4.Refer to Figure 5. Fold rubber gasket over installed wiring. Hold gasket tab to printed circuit board by folding tab over and sliding the removed plastic clip over tab and printed circuit board.

MOUNTING

Refer to Figure 6.

1.Carefully place excess wire into mounting frame.

2.Place gasket (furnished) into groove of mounting frame. Leave a small gap at the bottom center. Place edge of the remote control into the groove of the frame. Make sure the control and frame fit together tightly.

3.Secure remote control to frame with two (2) mounting screws (furnished).

RED	ORANGE
RED/WHITE	BLACK BLACK/WHITE ORANGE/WHITE

FIGURE 3

IMPORTANT – WHEN NUTONE MODEL IW-6R

WIRING IS USED:

CONNECT TO SCREWS ON PRINTED

CIRCUIT BOARD MARKED:

1ORN

2BLK

3BLK/WHITE

4ORN/WHITE

5RED

6RED/WHITE

BLUE STRIPE