MOUNTING
1.Refer to Figure 5. Carefully place excess wire into mounting frame.
2.Place gasket (furnished) into groove of mounting frame. The gasket will fit into both side and top grooves. The bottom of the frame where the weep slots are should not be filled with the gasket material.
3.Place edge of the outdoor speaker into groove of the mounting frame. Make sure the speaker and frame fit together tightly.
4.Secure speaker to frame with two (2) Nº 8 x 2˝ mounting screws (furnished).
RUBBER
GASKET
PRINTED
CIRCUIT
BOARD
PLASTIC CLIP
GASKET TAB
FIGURE 4
IMPORTANT – WHEN NUTONE MODEL IW-6R WIRING IS USED:
CONNECT TO SCREWS
ON PRINTED CIRCUIT
BOARD MARKED:
ORN
BLK
BLK/WHITE
ORN/WHITE
RED
RED/WHITE
BLUE STRIP
MAKE SURE GASKET IS | RUBBER |
COMPLETELY AGAINST | |
OUTSIDE RIM AND | GASKET |
PUSHED INTO |
|
THE GROOVE |
|
| |
SPEAKER |
|
| WEEP |
| SLOTS |
| FIGURE 5 |
Product specifications subject to change without notice. 4820 Red Bank Road, Cincinnati, Ohio 45227 Printed in China, Rev. 08/06, Part No. 61428