NuTone NP61000 manual Install the Ductwork, Install Mounting Brackets

INSTALL THE DUCTWORK

NOTE: To reduce the risk of fire, use only metal ductwork.

1.Decide where the ductwork will run between the hood and the outside.

2.A straight, short duct run will allow the hood to perform most efficiently.

3.Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible.

4.Install a roof or wall cap. Connect 6" round metal ductwork to cap and work back towards hood location. Use duct tape to seal the joints between ductwork sections.

INSTALL MOUNTING

BRACKETS

1.Construct wood wall framing that is flush with interior surface of wall studs.

Make sure:

a)the framing is centered over installation location.

b)the height of the framing will allow the mounting brackets to be secured to the framing within the dimensions shown.

2.After wall surface is finished, secure mounting brackets to framing using dimensions shown.

NOTE:

ROOF CAP	6” ROUND
	DUCT
DECORATIVE	WALL
FLUE
	CAP
HOOD	6” ROUND
	ELBOW
24” TO 30” ABOVE
COOKING SURFACE

FRAMING BEHIND DRYWALL

			5-7/8”
29						5-7/8”
	13
	/	”	to
cooktop				35	/	”
	16				13
							above
					16

2913/16"=bottom of hood 24" above cooktop 3513/16"=bottom of hood 30" above cooktop

-On 8’ ceilings, the hood distance above cook top is : minimum 24”, maximum 27-1/2”.

-On 9’ ceilings, the hood distance above cook top is :

-minimum 27”, maximum 30” (for Ducted Configuration).

-minimum 24”, maximum 30” (for Non-Ducted Configuration).

- 5 -