INSTALL THE FAN

Low Profile Installations Only

1.Remove canopy bottom cover from the canopy. (FIG. 7)

2.Remove three of the six screws and lock- washers (every other one) securing the mo- tor collar to the top of the fan motor housing. (FIG. 8).

3.Place canopy on top of motor housing, align the three holes and reinstall the three screws. Tighten all three screws securely.

4.Place motor assembly onto mounting bracket. The hole in the canopy should hang on the hook on the mounting bracket. (FIG. 9)

5.Cut motor wires to proper length.

6.After making electrical connections, (See page 5), push canopy up onto mounting bracket and turn motor so slots in canopy engage two screws. (FIG. 10) Tighten both screws, then install two other screws. Tighten all four screws securely.

CAUTION

At least four screws must be used to fasten the canopy/motor assembly to the mounting bracket.

FIG. 7

CANOPY BOTTOM

COVER

CUBIERTA DEL

ESCUDETE

FIG. 8

SCREWS (3)

TORNILLOS (3)

CANOPY

CUPOLA

COUPLING

ACOPLE

INSTALE EL VENTILADOR

Instalaciones de bajo perfil solamente

1.Qute la cubierta del escudete del escudete. (FIG. 7)

2.Remover tres de los seis tornillos y arandelas de seguirdad (dejando uno por medio) asegurando el collarín del motor localizado en la parte superior de la cubierta del motor. (FIG. 8)

3.Coloque la cúpola en el tope de la carcasa del motor, alinee los tres agujeros y reponga los cuatro tornillos. Apriete bien todos los tres tornillos.

4.Coloque el conjunto motor en la ménsula de montaje. El hueco de la cúpola deberá insertar en el gancho de la ménsula de montaje. (FIG. 9)

5.Corte los alambres del motor al largo requerido.

6.Después de hacer las conexiones eléctricas (vea la pág. 5) empuje la cúpola hacia la ménsula de montaje y dé vuelta el motor hasta que la ranura de la cúpola enganche los dos tornillos. (FIG. 10) Apriete ambos tornillos y luego instale los otros dos tornillos. Apriete bien los cuatro tornillos.

PRECAUCION

Por lo menos cuatro tornillos deben usarse para sujetar el conjunto cúpola/motor a la ménsula de montaje.

FIG. 9

HOOK

GANCHO

MOUNTING

BRACKET

MENSULA DE

MONTAJE

CANOPY

CUPOLA

MOTOR ASSEMBLY

CONJUNTO MOTOR

FIG. 10

SCREWS (4)

TORNILLOS (4)

SLOT

RANURA

CANOPY

CUPOLA

4