INSTALLATION INSTRUCTIONS READ & SAVE THESE INSTRUCTIONS!
Ceiling Fan Light Kits
Models: PFLK-123 Series
IMPORTANT: These Ceiling Fan Light Kits are for use with NuTone Model
CAUTION
1.CAUTION - To reduce the risk of fire and electrical shock, this light kit should be used only with NuTone fan model
2.Read entire instructions carefully before beginning installation.
3.CAUTION - To reduce the risk of electrical shock, disconnect the electrical supply circuit to the fan before installing the light kit.
4.All wiring must be in accordance with national and local electrical codes. If you are unfamiliar with wiring, you should use a qualified electrician.
SWITCH
HOUSING
PIPE, NIPPLE, |
| COVER PLATE |
NUTS, ETC. |
|
|
FIGURE 1
MAKING THE CONNECTIONS
NOTE: See fan instructions for connecting house wiring to the fan. Connect house wiring to the fan before attaching light kit to the fan. See wiring diagrams on back of this page, titled wiring wall switches.
1.Refer to Figures 1. Remove the cover plate from the bottom of the fan switch housing.
2.Assemble the cover plate to the light kit as shown. Use the pipe nipple and nuts provided.
3.Locate the two wires in the fan switch housing that have labels marked “Connect Light Here” or “For Light Use”. One wire will be white and the second will be black or blue with or without white tracer. Connect these wires to the wires coming from the light kit. Assemble the light kit to
the fan using the screws removed in step 1 (one) above.
COMPLETING THE INSTALLATION
FAN AND LIGHT ON A SINGLE WALL SWITCH WHITE
| WHITE WIRE | WIRE | |
115 VOLT SUPPLY |
| BLACK WIRE | |
|
| ||
| BLACK WIRE | WITH TRACER | |
| OR BLUE WIRE | ||
| MOTOR |
| |
| CONNECTIONS |
| |
| CEILING | ||
| BLACK WIRE | ||
| FAN | ||
| WITH TRACER | WHITE | |
| OR BLUE WIRE | ||
WALL | WIRES | ||
BLACK | |||
SWITCH |
| ||
WIRE |
| ||
|
| ||
| LIGHT KIT | FIGURE 2 |
1.Install (1) 100 watt maximum light bulb. Note: Refer to the guide for maximum size bulb that is printed on the
light fixture.
2.Should light shade begin to buzz, be certain all thumbscrews are tight.
WIRING WITH WALL SWITCHES
The Ceiling Fan and Light Kit can be connected through wall switches. This can be done in two ways. Select the type of control desired and wire the unit according to Figure 2 or Figure 3.
Use one wall switch to control both fan and light. Individual control of either fan or light is done with the pull chain switches.Or use two wall switches to individually control both fan and light – one for the fan and the second for the light. Pull chain switches on the fan do not have to be used.
WALL
SWITCH
FOR FAN
| WHITE | |
| WIRE | |
| BLACK WIRE | |
| WITH TRACER | |
| OR BLUE WIRE | |
BLACK WIRE |
| |
MOTOR |
| |
CONNECTIONS |
| |
| ||
BLACK WIRE | CEILING | |
FAN | ||
WITH TRACER | ||
| ||
OR BLUE WIRE | WHITE | |
BLACK | WIRES | |
| ||
WIRE |
| |
LIGHT KIT | FIGURE 3 | |
|
