READ & SAVE THESE INSTRUCTIONS! INSTALLATION INSTRUCTIONS
Timer Switches
MODELS: VS-62WH, VS-63WH
CAUTION: Do not supply house power until installation is complete.
All wiring must comply with local codes and switch must be properly grounded.
1. The timer assembly is designed to mount in a |
2. Run house power wiring (with ground) from fuse or |
circuit breaker box and wiring from ventilation fan (refer |
to fan motor plate for wiring instructions to motor) to |
timer in outlet box and make connections as illustrated in |
Figure 1. |
3. Strip wires approximately 1/2" to make connections. |
Connect wire to terminal screws in timer side. NOTE: |
Use |
|
TO NUTONE UNIT
WHITE | (NEUTRAL) | BLACK (HOT) | GROUND |
|
|
|
|
| TIMER |
|
|
WHITE | (NEUTRAL) | BLACK (HOT) | EARTH | GROUND | (GREEN) |
| timing period. |
4. | Insert wired timer into wall box with “TOP” (indicated on |
| front cover) in proper position. Refer to Figure 2. |
5. | Fasten timer to wall box using (2) screws provided. |
6. | Fasten wall plate to timer using the (2) screws provided |
| with the plate. The screw must be |
| timer body and will require a gentle inward pressure |
| while firmly turning the screw. |
7. | Position small plastic timer dial so that “OFF” is in the |
| up position. Install hex nut and tighten. |
8. | Push knob on shaft with the tail facing down. |
Timer Operating Instructions:
120 VAC 60 HZ HOUSE POWER
TOP
FIGURE 1
“OFF”
1.Turn knob clockwise (to the right) to desired time period. Timer will automatically turn “OFF” at the end of period.
2.Regardless of time period desired, knob must first be rotated past “TURN PAST” as indicated on timer dial. It may then be turned back to a shorter time period if desired.
POSITION
FIGURE 2
