MOUNTING THE THERMOSTAT'S

 

 

BLACK LEAD

BLACK LEAD

OUTLET BOX

 

 

FROM MOTOR

HOUSE SUPPLY

 

 

 

IMPORTANT: To assure proper operation of the

 

 

 

 

thermostat, it must not become covered by insulation and

 

 

 

 

must not be located adjacent to a heat source.

 

 

 

 

Secure the thermostat outlet box with screws or nails through

 

 

 

 

the mounting bracket and into wall stud or rafter. Position

 

 

 

 

flexible conduit so it does not touch fan sleeve.

 

 

 

 

ADJUSTING THE THERMOSTAT

 

 

 

HOUSE SUPPLY

 

 

SUPPLY

WIRING

The unit is shipped from the factory with the thermostat set at

 

 

 

 

 

GROUND

 

110°F. The fan will automatically be turned on when the

 

 

 

 

 

 

 

temperature in the attic reaches 110°F and will automatically be

 

FAN MOTOR

 

turned off when the temperature drops 10°F below the set

 

 

WIRING

 

temperature. The “start” temperature setting may be adjusted to

 

 

 

 

any setting between 60° and 120°F.

 

 

WHITE LEADS

 

 

 

 

FROM MOTOR

 

WIRING

 

 

AND HOUSE

FIGURE 3

 

 

SUPPLY

CAUTION: Be sure fan and switch are properly grounded

 

 

 

 

 

 

At the beginning of each ventilating season, check fan for any

and all wiring complies with electrical code requirements for

 

120vAC, 15 amp circuit.

 

debris that may be blocking fan blades, screen, or motor

1. Refer to Figure 3. Run 120vAC wiring to the outlet box and secure

ventilation openings.

 

with standard box connector.

 

 

 

2. If desired, an on/off switch may be installed at a convenient location.

To extend motor life, lubricate motor at the beginning of each

ventilating season. Oil ports are located on the front and back of

 

 

the motor. Use 5 or 6 drops of 20W non-detergent motor oil in

MAINTENANCE

each port.

 

CAUTION: Before cleaning or servicing unit, make sure

 

power is disconnected at service panel. (See important safety

 

instructions on page 1)

 

One Year Limited Warranty

WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one (1) year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED

WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this one year period, NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES, FILTERS, DUCT, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty installation or installation contrary to recommended installation instructions.

The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the address stated below or telephone 1/800-543-8687, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.

Date of Installation

Builder or Installer

 

 

Model No. and Product Description

 

 

IF YOU NEED ASSISTANCE OR SERVICE:

 

For the location of your nearest NuTone Independent Authorized Service Center:

 

Residents of the contiguous United States Dial Free 1-800-543-8687

 

Please be prepared to provide:

 

Product model number • Date and Proof of purchase • The nature of the difficulty

Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.

Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive, Mississauga, Ontario, Canada L5T 1H9.

Rev. 03/2001

Product specifications subject to change without notice. 4820 Red Bank Road, Cincinnati, Ohio 45227 Printed in U.S.A., Rev. 8/02, Part No. 87689

Page 2
Image 2
NuTone WF37, WF57NR Mounting the Thermostats, Outlet BOX, Adjusting the Thermostat, Wiring, Maintenance

WF57NR, WF37 specifications

The NuTone WF37 and WF57NR are powerful and versatile ventilation fans designed to elevate indoor air quality while enhancing the aesthetics of any space. These models are part of NuTone's esteemed range of bathroom and home ventilation solutions, emphasizing energy efficiency, noise reduction, and advanced technology.

One of the standout features of the WF37 and WF57NR is their powerful airflow capacity. With CFM ratings ideal for varying room sizes, these fans effectively remove humid air and odors, creating a more comfortable and pleasant environment. This is particularly beneficial in areas like bathrooms, kitchens, and laundry rooms where moisture and unwanted smells can accumulate quickly.

Both models incorporate innovative technologies aimed at maximizing energy efficiency. They are equipped with ENERGY STAR certification, which signifies that they meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. By consuming less power while delivering optimal performance, these fans contribute to lower utility bills and a reduced carbon footprint.

Noise reduction is another key characteristic of the WF37 and WF57NR models. With advanced sound-dampening technology, these fans operate quietly, ensuring that users can enjoy a peaceful environment without disruptive fan noise. This feature makes them ideal for installation in spaces where tranquility is paramount, such as bedrooms and home offices.

Installation simplicity is a fundamental aspect of NuTone's design philosophy. Both the WF37 and WF57NR come with straightforward installation instructions, allowing homeowners and contractors to set them up with minimal effort. They are designed to fit seamlessly into existing ductwork while also being compatible with various ceiling types, offering flexibility during installation.

Aesthetically, these fans are available in sleek designs that can complement a variety of interior décor. The WF57NR, for instance, features an appealing modern look that blends well with contemporary spaces. Additionally, both models are designed with easy-to-clean surfaces, ensuring that maintenance remains hassle-free.

In summary, the NuTone WF37 and WF57NR ventilation fans stand out with their powerful performance, energy efficiency, and quiet operation. With their modern aesthetic and thoughtful design, these models are perfect for anyone looking to enhance air quality while adding a touch of elegance to their home. Whether for a renovation or new construction, these fans provide a comprehensive solution to effective indoor air management.