06
REPLACEMENT PARTS
Replacement parts are available by calling Ocean Kayak customer service at
TROUBLESHOOTING
Motor fails to turn on or loses power after a short running time:
•Make sure the kill switch tether is in place.
•Check circuit breaker. The reset lever will be angled out at a
60 degree angle if blown. Reset by pressing the lever back in.
•Insure that the motor plug is fully inserted in the receptacle in the transom of the boat and that both are free of any corrosion.
•Check battery connections for proper polarity and make sure battery terminals are clean and corrosion free. Use fine sandpaper or emery cloth to clean terminals.
•Check battery charge, if low return to full charge.
•With battery disconnected make sure prop turns freely. Also check behind prop for obstructions and debris. See prop replacement instructions on page 5.
•Check that speed control knob is securely attached to pivot post.
•If this still doesn’t solve the issue, contact customer service.
Motor stops working completely after a short time:
•Turn the speed control dial to the “off” position. Then continue normal operation.
•Insure that the motor plug is fully inserted in the receptacle and that both are free of any corrosion.
•Check battery charge, if low return to full charge.
•Insure that the kill switch tether is in place.
You experience prop vibration or loud vibration noise coming from the motor during normal operation:
•Tighten motor tie down strap to reduce vibration.
•Remove and rotate the prop 180 degrees. See propeller replacement instructions on page 5.
•If prop is damaged replace with the MKP- prop kit (see page 5).
For all other techincal questions and concerns, contact Ocean Kayak customer service at
07
FREQUENTLY ASKED QUESTIONS
I pulled my kill switch and my battery died overnight, what happened?
The kill switch is not designed as an on/off switch but as an emergency kill switch. It is recommended to disconnect the battery for any prolonged storage to eliminate battery drainage.
My motor does not go directly into reverse from full speed. Is it broken?
The motor control unit requires being reset before switching from forward to reverse or reverse to forward. This process is simply setting the dial control to the off position for approximately
Can I install an after market prop on my motor to increase speed?
This is not recommended as it will increase the amp draw of the motor causing it to overheat. The use of any
How important is the battery selection for the electric motor usage?
The battery is a critical element of your electric motor system. A
What size battery do I need?
We recommend using a sealed 12 volt group 24 deep cycle battery with a mini- mum 85 amp hour rating. A group 24 is the largest size battery that can be used with the Torque kayak.
The batteries I have seen do not have an amp hour rating, they list a reserve capacity. How do I choose the right battery?
If an amp hour rating is not available, select a deep cycle marine battery with a minimum of 140 minute reserve capacity.
What do I need to recharge the battery?
We recommend using a
How long will it take to recharge the battery?
The amount of time it takes to recharge the battery will depend on the type of charger being used. A charger with a higher amp output will charge quicker.
How long will my kayak run on a fully charged battery?
The amount of
will have. As a general estimate, the Torque 12 volt motor will pull 25 amps at full speed.
