3
Windows TCP/IP
Network Installation (cont’d)
1 Assign an IP address to the MFP
If you are not using DHCP, you need to obtain an IP
Address from your network Administrator and
enter it using the front panel:
1. Confirm that the printer displays [Ready to
print].
2. Press ∇ key until [Admin Setup] appears. Press
ENTER.
3. Continue to Setup? displays. Press ENTER to
select Yes. The printer goes offline and Running
Setup displays. This will take about a minute.
4. The Setup Menu displays, press ∇ to select
Network Setup. Press ENTER.
5. Press ∇ to select Protocol Setup. Press ENTER.
6. Press ∇ to select TCP/IP Setup. Press ENTER.
7. Press ∇ to select Ethernet Se tup. Press ENTER.
8. TCP/IP Ethernet displays. Select Yes and press
ENTER. Enable AutoIP Config? displays. Select No.
Press ENTER.
9. The default IP Address displays. Use ∆ or ∇ to
change each octet. Press ENTER to proceed to
the next octet or to leave the octet unchanged.
10. Subnet Mask displays. Repeat instructions in
step 9.
11. TCP/IP bound to Ethe rnet displays. Press ENTER.
12. Gateway Address displays. Repeat instructions in
step 9.
13. Press ENTER to exit TCP/IP Setup, Protocol
Setup, and Network Setup.
14. Select Yes and press ENTER to Save Changes.
Press ENTER to Exit the Setup Menu.
15. Printer restarts the server and initializes. Ready
to Print displays.