48
EN
Continuous firing

For your safety,

be sure to observe the following.

Continuous firings make the light-emitting section hot and may result in

its deterioration, malfunction or deformation. Therefore, continuous firing

should be limited to the counts shown in the following table. Always leave

the electronic flash unused for at least 10 minutes after continuous firing

up to the limit count.

Limit counts of continuous firings

Flash intensity Flash interval Limit count

FULL; 1/1 1 sec. 10
1/2 0.5 sec. 20
1/4 0.3 sec. 40
1/8 - 1/128 0.2 sec. or less 80
Available counts of flash emission synchronized with continuous

shooting (at 8 frames/sec.)

The following table shows the flash emission count that can be

synchronized to the continuous shooting of the camera. Note, however,

that the electronic flash should be left unused for more than 10 minutes

once the maximum continuous flash emission count has been reached.

External power

supply

FL-50R

Internal

battery

Flash intensity

1/4 1/8 1/16 1/32 1/64 1/128

Without external
power supply With 2
frames 5
frames 10
frames 16
frames 30
frames 40
frames
Flash Power Grip
FP-1
(C (R14) alkaline
batteries/C (R14)
NiCd batteries)
With 2
frames 5
frames 16
frames 40
frames 40
frames 40
frames
Without 2
frames 5
frames 12
frames 18
frames 40
frames 40
frames
High Voltage Pack
HV-1
(NiMH battery pack
BN-1)
With 4
frames 40
frames 40
frames 40
frames 40
frames 40
frames
Without 4
frames 20
frames 40
frames 40
frames 40
frames 40
frames