33
Shooting basics
Using the flash
In the auto-flash mode (factory default setting), the flash is designed to fire
automatically when shooting under low light or against strong backlight, but you
can change the flash mode to suit different shooting situations. Select the flash
mode best suited to the light conditions and the effect you want to achieve.
1Open the lens barrier.
The camera turns on in the shooting
mode.
2Press .
The current flash setting is displayed.
3Press while the current flash
setting is displayed.
Each time you press , the flash mode is
switched in the following sequence:
AUTO - - - - -
.
4Take the picture.
• The flash working range is approximately 2.5 m/8.2 ft.
• The camera returns to the auto-flash mode (factory default setting)
when the lens barrier is closed. “Saving the settings (All Reset)”
( p.78)
• While the green lamp is blinking, the flash is charging and shooting is
not possible. Wait until the lamp goes off, then retry shooting.
• If you use the flash when shooting at a close distance, shadows may
be conspicuous and the correct exposure may not be achieved.
• In sequential shooting, panorama or movie mode, the flash is disabled.