Olympus MR-500i manual 107

		Troubleshooting
Problem	Cause	Solution	Page
Touch Panel does	The HOLD function is set to	Press HOLD to release the HOLD	22
not work.	ON.	function.
The device	The temperature of the device	This is not a malfunction.
becomes hot.	increases after extended periods		–
	of operation.
The battery	The battery should be replaced.	The built-in battery is good for about
discharges soon		500 complete charges and discharges,
after charging.		depending on usage. If the battery	–
		discharges soon after charging, contact
		your nearest Olympus service center for
		battery replacement.
Nothing is	The battery is empty.	Charge the battery with the supplied AC	23
displayed on the		adapter.
screen.
	The HOLD function is set to	The screen disappears when HOLD is
	ON.	set to ON. Press HOLD to release the	22
		HOLD function.
The screen is	The LCD brightness setting is	Adjust the setting of the LCD	100
dark.	too low.	brightness.
The backlight of	The backlight is set to turn off.	Set the desired time or change		Additional
the screen turns		“BACKLIGHT” to “ON.”	100
off.
There is no	The volume is set to minimum.	Adjust the volume on the device or	20
sound.		remote.	34	Information
			69
			78
	The remote or headphones are	Check whether the remote/headphones	21
	not connected properly.	are connected to the device properly.
The image is out	The subject is too close.	Always be at least 40 cm (15 3/4 in.)	–
of focus.		from the subject when shooting.
	The device moved during	Hold the device firmly and touch the
	shooting when you touched the	center of the screen lightly to avoid blur	48
	screen.	when shooting.

107