E-5
Screw the camera table provided with the PT-E
series case firmly into the bottom of the cam-
era.
5Loading the Camera and Lens
After attaching the gear to the camera’s lens, insert the camera and lens into the PT-E series case on which
the PPO-E03 is mounted.
Remove the eyecup from the camera’s viewfind-
er. If a lens cap or filter is attached to the lens or
the strap is attached to the camera, remove them
as well.
Pull up the power switch dial, mode dial knob
and zoom/MF dial on the PT-E series case,
and turn the case’s camera table lock lever
counterclockwise to release the lock. Attach the
flash hot shoe cable as instructed in the PT-E
series case manual.
Zoom/MF dial
Mode dial knob
Power switch dial
Camera table lock lever
Confirm that the camera’s power switch is OFF.
While pulling out the zoom/MF dial on the PT-E
series case , slide the camera table with cam-
era attached as far as it will go into the camera
table mount on the inner side of the case’s front
lid.
Pull out the zoom/MF
dial further.