Olympus T-10 40EN, Turning on the camera with the q button [qPOWER ON], Saving the mode when the camera is turned off [KEEP KSETTINGS], Setting the operation sound [BEEP]

Even if a computer has USB ports, proper operation is not guaranteed in the following cases.

●computers with USB ports installed using an expansion card, etc.

●computers without a factory-installed OS and home-built computers

Turning on the camera with the q button [qPOWER ON]

r(Settings 1) X qPOWER ON

Submenu 2	Application
	The camera is not turned on. To turn
NO	on the camera, press the n
	button.
	Press and hold the qbutton to turn
YES
	the camera on in playback mode.

Saving the mode when the camera is turned off [KEEP KSETTINGS]

r(Settings 1) X KEEP KSETTINGS

Submenu 2	Application
	The shooting mode is saved when
	the camera is turned off and is
YES
	reactivated the next time the camera
	is turned on.
NO	The shooting mode is set to P mode
	when the camera is turned on.

40EN

Setting the operation sound [BEEP]

r(Settings 1) X BEEP

Submenu 2	Application
	Turns off or on the operating
OFF/ON	sound/warning sound of the camera
	buttons.

Adjusting the CCD and the image processing function [PIXEL MAPPING]

r(Settings 1) X PIXEL MAPPING

This function has already been adjusted at factory shipping, and no adjustment is needed right after purchase. Approximately once a year is recommended.

For best results, wait at least one minute after taking or viewing pictures before performing pixel mapping. If the camera is turned off during pixel mapping, be sure to perform it again.

To adjust the CCD and the image processing function

Press the H button when [START] (Submenu 2) is displayed.

●The camera checks and adjusts the CCD and the image processing function at the same time.

Adjusting the brightness of the monitor [s]

s(Settings 2) X s

	Submenu 2	Application
		Selects the monitor brightness
	BRIGHT/
		depending on the surrounding
NORMAL
		brightness.