DPG10L | M3367/0606 |
|
|
• Instructions
The model DPG10L Digital Pressure Gauge has several features not normally found as standard in Digital Pressure Gauges. These include the Analog Scale, Tare, and Peak Holds. The Analog Scale is a 40 segment display that appears around the edge of the liquid crystal display. This scale represents the pressure reading as a percentage of full scale, and each individual segment equals 2.5%. The Tare feature provides a method of zeroing out an existing offset such as the weight of the platform on a hydraulic scale. The Hold feature allows the user to select Hi or Lo. When the Hold is enabled the reading displayed is the highest or lowest pressure experienced in the system since Hold was enabled, and this information will continue to be updated at the rate of six times a second until Hold is disabled.
1.0To Zero or “TARE OUT” an existing offset
1.1Press and hold the “MODE” key until the reading starts flashing. Release “MODE” key.
1.2Press “ENTR” key until the reading becomes 0000. NOTE: Tare range is 100% of Full Scale.
1.3To return to the Gross reading press and hold “ENTR”, then with “ENTR” still depressed press “MODE” until the reading returns to the gross, then release both keys.
2.0To select PEAK HI or PEAK LO hold functions
2.1Press and hold the “MODE” key until the reading starts flashing. Release the “MODE” key, then press “MODE” key once more, the display will read “HOLD”. Press “ENTR” key once, the display will read “NO H”. Using “up” or “down” keys select “NO H” (no Hold), “H Lo” (Peak Low Hold), or “H Hi” (Peak High Hold). Press “ENTR” key to lock your selection.
NOTE: When the Hold function is enabled “PEAK” is displayed, this will be the same for “Hi” or “Lo” Hold. You must remember which you have engaged.
2.2To reset after capturing a Hi Peak or Lo Peak, Press and hold “MODE” key until the reading starts flashing. Release the “MODE” key, then press “ENTR”, hold momentarily then release.
