3.Memory function
The measured and displayed blood pressure and pulse values are auto- matically stored in the memory.
The memory can store the values of up to 7 measurements.
Once the memory has 7 measurement values the next reading will be stored and the oldest reading will be erased.
The measured values stored in the memory will not be erased even when the batteries are replaced.
4.How to recall previous measured values from the memory
English
If there is no measured value in the memory, the display shown to the right is indicated when the MEMORY Button "M" is pushed.
5. How to erase the memory
By pushing the memory button, you can recall and display the measured values from the memory starting from the last measured value. This
is possible after measurement or directly when device is switched off.
When you push the MEMORY Button "M", if there is any measured value stored in the memory, M1 indicates the latest memory values. The systolic and the diastolic blood pressures and the pulse are displayed alternatively.
In order to recall the values measured previously, push the MEMORY Button "M" again.
All the measured values stored in the memory can be erased simul- taneously by operating the Buttons as follows:
While the ( M ) symbol is displayed, push the MEMORY "M" and the START Buttons simultaneously and keep on pushing them. After two seconds, the display shown to the right is indicated and the measured values stored in the memory will be erased.
All stored measurements will be erased. Because this monitor can store the measured values, you can measure even while you are out, then recall and use the results after returning home.
6
