One for All 3032, URC 3030 Easy 3, 3033, 3031 Installing the Batteries, Setting Up Your Devices

Press TV* and release. Press and hold SETUP until the One For All® Easy 3 Device's red light blinks twice. Release SETUP.

Step 1: Installing the Batteries

Your One For All® Easy 3 Device needs two (2) new AAA alkaline batteries. To install the batteries:

Step 3: Setting Up Your Devices

1	Turn on your TV, VCR or Cable Box, depending on the
	device you are programming.

1

2

On the back of the One For All® Easy 3 Device, push down on the tab and lift the cover off.

Match the batteries to the + and - marks inside the battery case, then insert the batteries.

2

TV

+

* Note: When setting up your VCR and/or Cable Box, substitute the appropriate device key (VCR or CBL).

SETUP

3

4

POWER

Press the battery cover back into place.

Test the unit by pressing POWER. The red light (LED) should blink once.

3

Using the example shown on the right, enter the first four-digit code you wrote down for the device you are setting up. (See "Looking Up Your

How to Enter Codes

If your TV

Press
code is:
1	1
	VOL

Note: Removing the batteries for more than 30 minutes will require you to reprogram the remote control.

Step 2: Looking Up Your Electronic Device Code

1	Look at your Electronic Device to find out the brand name and
	write it in the space below:
	TV	________________________
	VCR	_______________________
	Cable	_______________________

4

Electronic Device Code".) If you put in the code correctly, the red light will blink twice.

TV Set Up

2	VOL
	2
3	3
	CH+
4	CH-

4

2	Set-Up Codes		Find your Device brand in the listing on the re-
			verse side of these instructions. The most
	RCA	1213	popular codes are listed first. Write your codes
	Sony	1111
			here:

1st TV code

2nd TV code

3rd TV code

1st VCR code

2nd VCR code

3rd VCR code

1st Cable code

2nd Cable code

3rd Cable Code

You will need one of these codes to program your One For All®

Easy 3 Device remote.

POWER

POWER

or

PLAY

POWER

or

3

CH+

Aim the One For All® Easy3 Device at your TV and press POWER. Your TV should turn off. If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your TV.

VCR Set Up

Aim the One For All® Easy3 Device at your VCR and press POWER. Your VCR should turn off. If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your VCR. If your original VCR remote did not have a POWER key, put a tape in your VCR and press PLAY on the One For All® Easy3 Device.

Cable Set Up

Aim the One For All® So Easy 3 Device at your Cable Box and press POWER. Your Cable Box should turn off. If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your Cable Box. If your original Cable Box remote did not have a "ON" key, Use CH + on the One For All® Easy 3 Device to turn your Cable Box on.